FOR SALE - Perazzi MX8 32" O/U barrels LOWERED

I have a set of MX8 32" O/U barrels that have been Pro Ported and Wilkinson did the fixed chokes but it is not stamped. The bore is 733 and the chokes are 25th top and 12th bottom. Bluing is very good. Ser # 67704

(( $2200 Delivered to your address in the Lower 48 ))

Any questions please send a conv message for info and contact # -- Thanks Bob

 

Are you sure this is an mx8 o/u barrel?

 

It says Perazzi on the side of the barrel. Kind of hard to read but it is there. How tall is the rib in mm?

 

It says -- Imported - Perazzi USA - Rome - New York and the rib looks to be about 11 mm high and width looks to be 11mm x 8mm

 

That's MX-3, Mx-3 Special or Ga-88 barrels

 

Thanks for the info and they have to be an MX3 Special or GA-88 because they are type 4 barrel lug

 

What is is a perazzi Ga 88???

 

Grand American 88

 

Thanks!

 

Looks like MX-3 Special barrels. Regular MX-3 would have a round monobloc. The only bummer (for me) is the porting. Even then, if the bluing is good and it isn't all dinged up, at $2200 shipped, that's a steal. If I didn't already have a couple sets of those, I'd be all over them.

 

Thanks Mark and the precious owner told me they were on his MX3 Special and he bought a set of 30" barrels to shoot doubles with

 

just might be off a DB-81

 

MX3 Special Barrels work very nice on a MX 15 to make a combo.

 

Is this something you had done . What is the reasoning behind this. Thanks

 

Richie h you have a conv message

 

I have done the same, put mx3 special o/u on mx15. The mx3 rib is just a little lower than the flattest setting of the mx15 rib.

 

richie h
To make the MX15 a combo

 

LOWERED to $2150

 

UP

 

i'm looking for a type4, 32", w "4mm" rib - my understanding is 4mm is not the height from barrel to top of the rib but some other perazziesque measurement. if so do you know if this barrel came from the original receiver or prev fitted to another. thx!