a fellow at the club gave me to work up a load with titigroup,but does not have a powder bushing a numbe 342 for 1200 fps and a 351 for 1255 pfs,i told him that i would make them for him ,i have a lathe,i need to no the inside diameter of both those bushing if any one has those numbers...i thank you
And those bushings might not throw the correct amount - best to weigh 10 drops with the closest one and adjust. Using a bushing chart to determine loads is kinda risky.
Bushings are hard to find for that machine. I ended up buying some made from plastic or such material off of eBay but they work well and they’re reasonable. I found one shot bushing and haven’t seen any others however someone said they ordered some direct from Hornady.
Actually since you have a lathe you could turn an adapter to use readily available MEC bushings in the Hornady press.
Bushings are available through Hornady and Midway for sure. i have not had any problems getting the bushing I needed.
