FOR SALE - MX3 Special 32" O/U barrels SOLD

I have a set of MX8 32" O/U barrels that have been Pro Ported and Wilkinson did the fixed chokes but it is not stamped. The bore is 733 and the chokes are 25th top and 12th bottom. Bluing is very good. Ser # 67704

(( $2150 Delivered to your address in the Lower 48 ))

Any questions please send a conv message for info and contact # -- Thanks Bob

 

bobby are they mx 3 or mx 8 ? thanks

 

Fireh2o. They are MX3

 

Jack,
Take a look at the photos, square mon o block. Should be MX 3 Special same as MX8.

 

What is the difference between MX3 Special barrels and MX8 barrels? Same style of receiver. How do you tell? Asking to get a little smarter from the experts, thanks.

 

Just an abreviated comment. Obvious it is a square mono Special set. And the difference is a square mono block MX3 Special WILL NOT fit into a round mono block MX3. However there is a rare exception. Likely, you will never see one in your lifetime

 

FYI the MX3 Special as well as the round mono block MX3 barrel ribs are the same height.
The MX3 rib height is about 1/8" higher then the MX8 ribs.
The MX3 o/u barrels have no side ventilated rids.
The MX3 Special barrels will fit MX8 receivers.
The MX3 Special was discontinued in 1992 I believe.
All MX3,s had 18.4-18.5 bores or there about. .725+-.
MX3 Specials had internal selectable triggers.
The MX3 was before the Special.
The MX3 fired top barrel first only.
Therefore on the MX3 O/U the top barrel was the more open choke and bottom barrel was tighter choke.
Both of these models were shooting machines.
They could be perchased with Perazzi second Generation choke tubes.(treads towards breech of the gun not the muzzle)
The O/u barrels didn't have the option of choke tubes.

 

Old 49 has good data

 

Thanks guys, this should answer any questions on this barrel

 

The top single barrel of my mx3 special combo has gen 4 choke tubes.

 

Do you still have the MX 3 Special 32" barrels ??
PM me JJM

 

SOLD -- Thanks everybody for looking -- Bob