Brad Dysinger

Discussion in 'Trapshooting Forum - Americantrapshooter.com' started by dr.longshot, Jan 5, 2022.

  1. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    I got a 1939 Model 12 Milled Rib Model 12, 30 inch Bbl, says Model 12 Trap on the Magazine tube, Ser# 80k.
    I always wanted one, now I got it.

    GB.........................................DLS
     
    Ken Cerney likes this.
  2. mudpack

    mudpack Mega Poster Founding Member

    Good on ya', mate.
     
  3. rookieshooter

    rookieshooter Mega Poster Forum Leader

    Never too late for a fine gun.
     
  4. Flyersarebest

    Flyersarebest Moderator Founding Member Forum Leader

    What's the over/under number on how long Doc keeps it?
     
    just joe and Roger Coveleskie like this.
  5. BRAD DYSINGER

    BRAD DYSINGER The Philosophist Founding Member Member Trapshooting Hall of Fame Member State Hall of Fame

    I just wonder how much it cost him, nice gun Doc.
     
    Flyersarebest likes this.
  6. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    Brad I got top dollar in it Brad, trading that Beretta 391 soft touch in an even trade, What's nice is it is a 1939 Milled Rib Trap, Marked Model 12 Trap on the Magazine Tube, Tight fitting yet,used very little. I will be keeping it. Very tight Choke, my specialty. Love extra full chokes. In the early days of my shooting I had a solid rib Black Diamond. Like a fool I had Simmons install a ventilated rib with a model 12 spade Ramp installed, I won a lot of money with gun, purchased it at a Pawn Shop in Mt. Vernon, Ohio. Thanx Brad.

    GB..................................................DLS
     
    BRAD DYSINGER likes this.
  7. T Jordan

    T Jordan Well-Known Member V I P

    I bought a Y model last summer it is still in the original box with the owners book.This gun has never even been fired. I paid about $1250 US for it. I started shooting Trap with one and just wanted one. A friend had it and my son will end up using it.
     
  8. T Jordan

    T Jordan Well-Known Member V I P

    I put my barrel mic in it and it has 42 thou of choke, it should hit targets hard.
     
  9. mudpack

    mudpack Mega Poster Founding Member

    You might want to put some patterns on paper; there comes a point in choke constriction where too much can disrupt patterns.
     
    T Jordan likes this.
  10. dfwip9x

    dfwip9x Well-Known Member

    What mudpack said. I bought a model 12 years ago that just would not shoot. Constriction was tight, but did not start until the very end of the barrel. Pattern was awful. Tom Wilkinson turned it into a target crusher. Said it was the worst factory barrel he had ever seen.....
     
    T Jordan likes this.