Is Herco an orphan?

Discussion in 'Reloading Bench' started by Trap Haus, Feb 4, 2017.

  1. Trap Haus

    Trap Haus Active Member Founding Member

    I recently bought some Herco powder, the Alliant manual has loading information for an 1-1/8 load, but I have not seen any data on it as far as patterns, or any mention of it in any capacity. My thinking is that Green Dot, being so a slower powder, that Herco would be even better, in that it is the slowest. What might I expect from it? .....Just some mid-winter musings from my loading bench.
     
  2. Shooting Coach

    Shooting Coach Well-Known Member Founding Member

    Fairly dirty in ATA legal loads. Seems to work very well as far as smoking the target. Need to use quite a bit.
     
  3. Trap Haus

    Trap Haus Active Member Founding Member

    Thanks, I did a search about it and found out some info. Shot some HDCP last week with Herco and did well recoil wise..
     
  4. Shooting Coach

    Shooting Coach Well-Known Member Founding Member

    Herco is a great caps powder. Don't be afraid to use three tablespoons, and keep speeds at 1250 or better. The Windjammer wad with Herco does spectacular things to targets a long way off.
     
  5. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    All are right,25grs Herco, Nitro 27 hull, Windjammer Wad, CCI209M Primer 1 1/8th shot+1250fps, soft shooting TARGET GRINDER, Right out of Alliant Reloaders Manual 9400psi.

    GB............................................DLS
     
  6. jansonuhl

    jansonuhl jansonuhl

    I use 19.7 gr in a 16 ga. load. Book i believe.
     
    Trap Haus likes this.
  7. Dan 513

    Dan 513 Member

    Herco is hands down one of the best powders made. There has been more Calcutta’s won with it then any other. I dump the pepper out of the shaker and put Herco in it. Like Franks I put that $hit on everything.
     
  8. Shooting Coach

    Shooting Coach Well-Known Member Founding Member

    I load Herco in 20 ga Riefenhauser hulls for tube guns May be the best powder for these hulls. Lower pressure, easy on everything except the target. Also, a better powder in the 28 than Unique. Same deal, lower pressures, a beast on targets.

    With the right hulls and wads, 10 to 28 ga, works well.
     
  9. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    Remington Herco 1 1/8th oz loads @1250 fps CCI-209M Primer 24.4 grs @8800psi need a hotter Primer to Light it off
    24.5 grs 9800psi RXP wad
    25.0 grs 9400psi Windjammer
    When you load the AA hull it goes to 1425Fps same amount of Herco 24.5 grs same wads RXP-Windjammer
     
  10. dr.longshot

    dr.longshot Grudge Match Champion Founding Member Forum Leader Grudge Match Champion

    Federal Gold Medals Versalite Wad Fed 209A Primer 26 grs Herco 8200 psi 1200fps
    " " " RXP " " " " " 8000 psi "
    Windjammer 7400 psi "
    Win AA 8300 psi "
    All it does is add to powder cost, lower Pressures, tighter Patterns
    I like it in Top Gun Hulls same results w/Herco
    GB............................DLS
     
  11. Mauserfan

    Mauserfan Active Member

    I use it for great 20 ga loads as well....very low recoil and will operate a semi auto.
    Darrel
     
  12. Jeff likes ribs

    Jeff likes ribs New Member

    Better then Unique in a 28ga? I would sure like to know how it is better.